|
THE ANNALS OF “DUNAREA DE JOS” UNIVERSITY
OF GALATI
Fascicle XII, WELDING EQUIPMENT AND TECHNOLOGY
ISSN 1221-4639 |
 |
Instructions for Authors
Manuscript submission
Submission of an article implies that the work described has not been
published previously (except in the form of an abstract or as part of a
published lecture or academic thesis), that it is not under
consideration for publication elsewhere and that, if accepted, it will
not be published elsewhere in the same form, in English or in any other
language, including electronically without the written consent of the
copyright-holder. Electronic submission substantially reduces the
editorial processing and reviewing times and shortens overall
publication times. The information on guidelines for writing and
preparing the contributions are included in the Paper Template. A
Copyright Agreement is required for all papers accepted for
publishing.
Copyright
Papers accepted for publication become the copyrighted property of The
Annals of Dunarea de Jos University of Galati, Welding Equipment and
Technology, Fascicle XII. No part of the publication may be reproduced
or transmitted in any form, or by any means, electronic or mechanical,
including photocopy, recording, or any information storage and retrieval
system, except in limited quantities for the non-commercial purposes of
scientific or educational advancement, without permission in writing
from the Editorial Board.
Plagiarism Policy
The Annals of Dunarea de Jos University of Galati, Welding Equipment and
Technology, Fascicle XII does not allow any form of plagiarism.
Plagiarism is considered to be a serious breach of scientific ethics by
the Journal. Incidents of plagiarism in a manuscript or published paper
whether detected or reported, will be dealt with severely in accordance
with the international laws.
The
Paper Template
can be downloaded from the following address:
AWET Paper Template.
The Copyright Agreement can be downloaded
from
the following address:
AWET Copyright Agreement.
Manuscripts should be submitted to:
The Annals of “Dunarea de Jos” University of Galati, Fascicle XII,
Welding Equipment and Technology
Dunarea de Jos University of Galati, Faculty of Mechanical Engineering
Department of Manufacturing, Robotics and Welding Engineering
111 Domneasca St., 800201 - Galati, Romania
Tel: +40 336 130212, Fax: +40 236 314463
Prof. Dr. Eng. Elena SCUTELNICU
E-mail: elena.scutelnicu@ugal.ro
or
Assist. Drd. Eng. Carmen Catalina RUSU
E-mail:
carmen.rusu@ugal.ro
|
